Eurocom D900F Panther Workstation User Manual download pdf (Page 104)

Upgrading The Computer

6 - 10 Upgrading the System Memory (RAM)

9. Gently pull the two release latches ( & ) on the sides of the memory socket in

the direction indicated by the arrows in Figure 6 - 8

10. The RAM module will pop-up, and you can remove it.

11. Pull the latches to release the second module if necessary.

12. Insert a new module holding it at about a 30° angle and fit the connectors firmly

into the memory socket.

13. The module’s pin alignment will allow it to only fit one way. Make sure the module

is seated as far into the socket as it will go. DO NOT FORCE the module; it should

fit without much pressure.

14. Press the module in and down towards the mainboard until the socket levers click

into place to secure the module.

15. Replace the heat sink unit (make sure you tighten the screws in the order

indicated on the label and in Figure 6 - 7), RAM fan, cover and screws.

16. Restart the computer to allow the BIOS will register the new memory configuration

as it starts up.



Single Memory

Module Installation

If your computer has a sin-

gle memory module, then in-

sert the module into the

Channel 0 (JDIMM2)

sock-

et as shown in

Figure 6 - 8

RAM Module

Removal



RAM Module Speeds

Use either 1066MHz OR

1333MHz DDRIII (DDR3)

modules of the same

brand. Do not mix DRAM

speeds/brands in order to

prevent unexpected sys-

tem behavior.

26 27

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 211 212

No comments

Eurocom D900F Panther Workstation User Manual Page 104