Eurocom Electra 2 User Manual download pdf (Page 147)

Upgrading The Computer

Upgrading the Hard Disk Drive 6 - 11

Removing the Solid State Drive

1. Turn off the computer, and turn it over and remove the battery (see page 6 - 3)

and component bay cover (see page 6 - 4/6 - 5).

2. The SSD slot is at point on the mainboard.

3. Remove screw , and the SSD

will pop-up and you can then remove it.

4. Replace the SSD by angling it as illustrated, and then fit the connector firmly into

the slot.

5. The SSD module’s pin alignment will allow it to only fit one way. Make sure the

module is seated as far into the slot as it will go. DO NOT FORCE the module; it

should fit without much pressure.

6. Press the SSD module down towards the mainboard and replace screw

and

the component bay cover.

Figure 6 - 8

Component Bay -

SSD Removal

1 2 ... 142 143 144 145 146 147 148 149 150 151 152 ... 259 260

No comments

Eurocom Electra 2 User Manual Page 147